Beko WMY 121444LB1 Manual Del Usuario página 27

Problem
Programme time does not
countdown. (On models with
display) (*)
Programme time does not
countdown. (*)
Machine does not switch to
spinning step. (*)
Washing performance is poor:
Laundry turns gray. (**)
Washing performance is poor:
Stains persist or the laundry is not
whitened. (**)
Washing performance is poor: Oily
stains appeared on the laundry. (**)
Washing performance is poor:
Clothes smell unpleasantly. (**)
Washing Machine / User's Manual
Reason
Timer may stop during water intake.
Timer may stop during heating step.
Timer may stop during spinning step.
There might be unbalanced load in the machine.
There might be unbalanced load in the machine.
The machine will not spin if water is not drained
completely.
Excessive foam might have occurred and automatic
foam absorption system might have been activated
due to too much detergent usage.
Insufficient amount of detergent has been used over a
long period of time.
Washing was made at low temperatures for a long
time.
Insufficient amount of detergent is used with hard
water.
Too much detergent is used.
Insufficient amount of detergent is used.
Excessive laundry was loaded in.
Wrong programme and temperature were selected.
Wrong type of detergent is used.
Too much detergent is used.
Regular drum cleaning is not applied.
Odours and bacteria layers are formed on the drum as
a result of continuous washing at lower temperatures
and/or in short programmes.
Solution
• Timer indicator will not countdown until the
machine takes in adequate amount of water. The
machine will wait until there is sufficient amount
of water to avoid poor washing results due to lack
of water. Timer indicator will resume countdown
after this.
• Timer indicator will not countdown until the
machine reaches the selected temperature.
• Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
• Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
• Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
• Check the filter and the draining hose.
• Use recommended amount of detergent.
• Use the recommended amount of detergent
appropriate for water hardness and the laundry.
• Select the proper temperature for the laundry to
be washed.
• Using insufficient amount of detergent with hard
water causes the soil to stick on the cloth and
this turns the cloth into gray in time. It is difficult
to eliminate graying once it happens. Use the
recommended amount of detergent appropriate
for water hardness and the laundry.
• Use the recommended amount of detergent
appropriate for water hardness and the laundry.
• Use the recommended amount of detergent
appropriate for water hardness and the laundry.
• Do not load the machine in excess. Load with
amounts recommended in the "Programme and
consumption table".
• Select the proper programme and temperature for
the laundry to be washed.
• Use original detergent appropriate for the
machine.
• Put the detergent in the correct compartment. Do
not mix the bleaching agent and the detergent
with each other.
• Clean the drum regularly. For this, please see
4.4.2.
• Leave the detergent drawer as well as the loading
door of the machine ajar after each washing.
Thus, a humid environment favorable for bacteria
cannot occur in the machine.
27 / EN