Programming The Rts Remote Control; General Information; Adding Or Removing The Monitor Rts Control With An Exiting "3-Button" Receiver; Programming A Somfy Rts Garage Door Motor - SOMFY VSYSTEMPRO Manual De Instalación

EN
SW4 = ON on the main monitor and on the secondary monitor: the video is displayed on the monitors configured with
SW4 = ON (max. two monitors) suring a call from an external module.
S8
ON ON
1 1
Note: it is possible to answer a call from an external module using a secondary monitor configured with SW4 = OFF, in which
case the video is displayed on this screen and is switched off on the secondary monitor configured with SW4 = ON.
For this type of configuration, it is necessary to use power supply ref. 9020028.

6 PROGRAMMING THE RTS REMOTE CONTROL

6.1 General information

The RTS remote control corresponding to the monitor can be used to control up to five Somfy products or groups of products
equipped with a RTS receiver.

6.2 Adding or removing the monitor RTS control with an exiting "3-button" receiver

[1]. RTS monitor control: select the channel to be memorised
[2]. RTS transmitter already memorised: Press "PROG" for 2 seconds (see the RTS transmitter instructions)
- The LED on the RTS receiver lights up or the product moves briefly.
[3]. RTS monitor control: Briefly press "PROG":
- The LED on the RTS receiver flashes or the product moves briefly. the RTS control channel for the monitor is
memorised (or deleted if it was already memorised).
Begin the procedure again for all channels to be memorised or deleted.
Note: To clear the videophone programming on an RTS receiver, repeat all the steps described above.

6.3 Programming a Somfy RTS garage door motor

[1]. Open the motor cover.
[2]. Check that the motor is switched on.
[3]. Select the channel by pressing the channel selection button on the monitor.
[4]. Press the settings button
- The motor settings indicator light comes on and stays on.
[5]. Briefly press the monitor opening button.
- The motor settings indicator light flashes then goes off.
[3] [4]
1..2..3..4..5
Note: To clear the programming on the video entry phone on a Somfy garage door motorisation, repeat all the steps detailed
above.
10
C10
C9 S8
ON ON ON
2 3 4 5 6 7 8 1 2 3 4 1 1
Adr . 1
Ext . 1
on the motor and hold down for 3 seconds.
[5]
3s
C10
C9 S8
ON ON ON
2 3 4 5 6 7 8 1 2 3 4 1 1
Adr . 1
Ext . 2
<0,5s
C10
C9 S8
ON ON ON
2 3 4 5 6 7 8 1 2 3 4 1 1
Adr . 1
Ext . 3
Copyright © 2016 Somfy SAS. All rights reserved.
C10
C9
ON
2 3 4 5 6 7 8 1 2 3 4
Adr . 1
Ext . 4