EN
On a Somfy RTS light receiver
Caution: The receiver uses a 230V power supply. Do not touch the terminal or the bare wires.
[1]. Open the light receiver.
[2]. Check that the receiver is switched on.
[3]. Press the PROG button on the receiver until the indicator light on the receiver comes on.
- The programming function is activated for 2 minutes.
[4]. Select the channel by pressing the channel selection button on the monitor.
[5]. Briefly press the PROG button at the back of the monitor (above the battery housing).
- The indicator light on the receiver flashes for 5 seconds.
[3]
2 mn
2 s
Note: To clear the video entry phone programming on a Somfy light receiver, repeat all the steps detailed above.
The electrical diagram must be adapted to the installation to be implemented. For more complex installations than those
presented below, please consult the diagrams book available as a pdf.
Note: The external module can control an electric lock or a motorised gate. To control both, a relay module is required, ref.
9020031.
7.1 Installation with an external "1-button" module and a monitor
1
See diagram
at the end of the document.
7.2 Installation with an external "1-button" module and two monitors
Bus line between the two monitors
2
See diagram
at the end of the document.
Bus line distributed via the electric panel
3
See diagram
at the end of the document.
7.3 Installation with an external "2-button" module and two monitors
4
See diagram
at the end of the document.
7.4 Push button for a remote buzzer
It is possible to connect an independent push button enabling the buzzer on the monitors to ring with a different tune
from that used for calls from an external module.
12
[4]
2s
1..2..3..4..5
7 ELECTRICAL DIAGRAMS
9020027
9020027
0
0
230V
230V
+BUS-
+BUS-
N L
230 VAC
50 Hz
[5]
Copyright © 2016 Somfy SAS. All rights reserved.
5 s
5 s