Cleaning And Maintenance - Bimar FFFRoid VR20 Manual De Instrucciones

4. When you press the MODE button (C) on the control panel or remote control, it
changes to NATURE mode: the NATURE indicator light will turn on.
5. SLEEP mode is activated by pressing the MODE button on the control panel or
remote control again: the SLEEP indicator light turns on.
6. Pressing the COOLER button (G) on the control panel or remote control activates
the function: the COOLER indicator light turns on.
7. When you press the SWING button (B) on the control panel or remote control, the
oscillation function turns on: the SWING indicator light will turn on. To turn off
oscillation, press the SWING button again.
8. When you press the IONIC button (F) on the control panel or remote control, the
function is activated: the IONIC indicator light will turn on indicating that the
ionizer is working. To turn this function off, press the key again.
9. When you press the Timer button (A) on the control panel or remote control, the
function is activated: each press of the button changes the time set; press once to
start a time of 1 hour, the corresponding 1hr light will turn on; press again to set
the time to 2 hours and the corresponding 2hr light will turn on; press it a third
time to set a time of 4 hours, the corresponding 4hr light will turn on; finally,
press it a fourth time and a time of 8 hours will be set, the corresponding 8hr light
will turn on. To turn this function off, press the button again (fifth time) and no
light will be on.
10. In all modes, the fan and cooler can run for a maximum of 24 hours, after which
the appliance stops automatically and goes to stand-by mode; to start it again,
press the ON/OFF button.
11. To turn off the appliance and put it in stand-by mode, press the ON/OFF
button on the control panel or remote control.
12. After each use, we recommend that you empty the tank of water using the
plug.
When not in use for long periods, the plug must always be removed from the
socket.

CLEANING AND MAINTENANCE

Attention: before normal cleaning, remove the plug from the socket.
The appliance works best if the filters and tank are clean.
• Periodically check that the rear intake filter (11) is not clogged with dust, lint, or
fibres. If it is dirty, remove it by pressing the two tabs (12), and clean the netting
with a brush or with water, being careful not to damage it; then dry it completely
and put it back in place.
• Periodically check that the honeycomb filter (20) is not dirty. If it is, remove it
from its seat and clean it with water with a little household detergent and use a
soft brush to clean the external honeycombs. Be careful not to damage the
honeycombs or other parts. Rinse thoroughly under the tap water and let it drip
dry before replacing it in its seat and check that no electrical parts are wet. If
they are, dry carefully and completely.
• To clean the tank and ice bricks, use water with a little detergent and a soft cloth
and wash carefully. Rinse the tank and bricks under running water and let drip
dry before replacing them in their seat.
•
To prevent lime deposits (or more frequently if the water is
very hard) or impurities, periodically clean out the holes in
the water using a brush or a brush, be careful not to
damage the holes.
14/41