Abicor Binzel MF1-Rear Instructivo De Servicio página 36

10 Troubleshooting
Weekly
• Remove the cover (1) and use dry
compressed air to clean the drive unit.
• Check the drive gear (6) for wear and
replace if necessary.
• Check the full-floating axles (10) and
toothed wheels (11) for wear and
replace if necessary.
• Check the feed rolls for wear and
replace if necessary.
 6.1 on page EN-9
Tab. 9 Maintenance and cleaning
10 Troubleshooting
Risk of injury and machine damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the
device. The product warranty will be rendered invalid if the device is handled by unauthorised persons.
• Operating, maintenance, cleaning and repair work may only be carried out by qualified personnel (in
Please observe the attached "Warranty" document. In the event of any doubts and/or problems, please
contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding components, such as the power source,
Fault Cause
Unit is not • Control system or component defective
ready for
operation
• Motor defective
• Motor control card fault. Fault cannot be
Wire is not fed eliminated by pressing the RESET trigger.
• When the wire feed trigger is pressed again, the
motor control card shows again a fault.
Tab. 10 Troubleshooting
EN - 18
Every other week
• Lightly lubricate the full-floating
axles (10) and toothed wheels (11)
with: K3N-30 Lithium NL GI class 3
• Check the wire guide nipple (7) for
wear and replace if necessary.
• Check the wire outlet nipple (3) for
wear and replace if necessary.
DANGER
Germany see TRBS 1203).
welding torch system, re-circulating cooling unit etc.
Monthly
• Check the contact pressure setting and
correct using the pressure screw (8) if
necessary.
• Check the pressure spring (9) for wear
and replace as follows if necessary:
Unscrew the pressure screw (8),
replace the pressure spring (9) and
screw in the pressure screw (8).
• Check the clamp lever (2) for wear and
replace if necessary.
Troubleshooting
• Ask a Binzel specialist to replace the defective control
system or component
 See BAL.0388.0 eBOX
 See BAL.0388.0 eBOX
 See BAL.0388.0 eBOX
MF1 rear