Mounting The Pressure Rolls En - Abicor Binzel MF1-Rear Instructivo De Servicio

6 Putting into operation
1 2
12
11
10 9
1
Eccentric bolt
2 Drive gears x 2
3 Knurled screws x 2
4 Feeder drive rolls x 2
Fig. 2 Mounting the feed rolls
6.1.1 Mounting the pressure rolls
1 Lift off the cover (5).
2 Press on the rocker (10) then rotate the eccentric bolt (1) and remove it upwards.
3 Unscrew the knurled screw (6) and lift off the rocker (10).
4 Loosen the knurled screws (7) and press out the axle (9) downward.
5 Remove the drive gears (11).
6 Place the feed rolls (12) on the drive gears (11).
7 Insert the drive gears (11) and axles (9) and secure in place using knurled screws (7).
8 Place the rocker (10) on the bolt and secure with the knurled screw (6).
9 Swivel the rocker (10) into position, insert the eccentric bolt (1) and turn it over.
10 Put on the cover (5).
EN - 10
3
8
5
Cover
6 Knurled screw
7 Knurled screws x 2
4
8
7 6
8
Pressure screw
9 Axles x 2
10 Rocker
MF1 rear
5
11 Drive gears x 2
12 Feeder pressure rolls x 2