Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel MF1-Rear Instructivo De Servicio

8 Putting out of operation

8 Putting out of operation
NOTICE
• As the MF1 rear is integrated into a welding system, the process for putting it out of operation
1 Switch off the power to the robot control system.

9 Maintenance and cleaning

Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Disconnect the mains plug.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
Risk of crushing
Limbs can be drawn in and crushed.
• Do not reach into moving wheels.
Risk of injury
Serious injuries may be caused by parts swirling around.
• When cleaning the wire guide with compressed air, wear suitable protective clothing, in particular
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel (in Germany see
• Observe the provisions of EN 60974-4 Inspection and testing during the operation of arc welding
• Always wear your personal protective clothing when performing maintenance and cleaning work.
EN - 16
depends on the robot control system. Please make sure that the shutdown procedures for all
components integrated in the welding system are strictly observed.
DANGER
DANGER
WARNING
WARNING
safety goggles.
TRBS 1203).
equipment plus any national laws and regulations.
MF1 rear