First Use - Nemox Gelato 12K Instrucciones Para El Uso

HOW TO CONNECT THE CORD TO A U.K. PLUG: IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
•Green and yellow:
•Blue:
•Brown:
Please, read the instructions given below before connecting the cord to a plug.
If in doubt, please, consult a qualified electrician. As the colours of the wires in
the mains lead of this appliance may not correspond with the coloured
markings identifyng the terminals in your plug, proceed as follows: the wire
that is coloured Green and Yellow must be connected to the terminal in the
plug which is marked with the letter E or the Earth symbol (G), or coloured
Green or Green and Yellow.
The wire that is coloured Brown must be connected to the terminal which is
marked with the letter L or coloured Red. The wire that is coloured Blue must be
connected to the terminal which is marked with the letter N or coloured Black.
SAFETY POINTS FOR REWIRABLE OR MOULDED PLUG
The mains lead of this appliance may be already fitted with a BS1363 13A plug.
•If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded on plug),
the flexible cord insulation should be stripped back as appropriate and a suitable 3 pin plug fitted.
•WARNING: Dispose of a plug that has been cut from the power supply cord, as such a plug is hazardous if
inserted in a live 13A socket outlet elsewhere in the house.
•Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating must be
used.
•Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a
replacement is obtained. Make certain that only the correct fuse cover is used and fitted.
•For plugs with detachable fuse cover, the replacement must be the same as the colour insert in the base of the
plug, or as directed by the embossed wording on the base of the plug.
•If the detachable fuse cover is lost a replacement may be purchased from a Service Centre.
•Information for supply may also be obtained from the plug manufacturer.
1). Refrigeration system knob.
2). Mixing paddle and rotation sense knob.
3). Transparent lid.
3a). Ingredients adding hole.
4). Paddle locking nut.
5). Mixing paddle with inserts.
6). Ventilation slot.
7). Speed adjusting knob.
8). Support frame for tray.
9). Extrusion flat gate handle.
10). Power switch.
11). Ice cream chute.
12). Support frame fixation screws.
Congratulations!
You have purchased a latest generation
NEMOX ice cream machine.
The operation of the compressor and
paddle are independent so as to make the
most of your experience.
An electronic device stops the paddle when
the consistency of the preparation is
excessive, thus preventing compromising
the mechanical functions of the machine.
English
UK USERS ONLY
Earth
Neutral
Live
13). Flat gate fixation screws.
14). Chute fixation screw.
15). Paddle plastic sleeve gasket set.
16). Extrusion gate gasket set.
17). Paddle plastic sleeve.
18). Vertical scraper.
19). Horizontal scraper.
20). Interlocking buffer.
21). Small vertical scraper.
22). Oil seal.
23). Spatula.
The cooling system will continue to run until
it is manually stopped.

FIRST USE

•Place GELATO 12K
sure that the ventilation grids (6) are not
obstructed. Leave a minimum clearance
of 10 cm. around the ventilation grids.
•During use, the appliance must be kept
clear of walls or furniture so as to not
obstruct the inflow and outflow of cooling
on a flat surface, make
5