Technical Data - Grohe F-digital 36 309 Manual Del Usaurio

GB
Safety notes
• Installation is only possible in frost-free rooms.
• The maximum permissible distance between the digital
controller/diverter and the functional unit is 5 m.

Technical data

• Radio frequency:
• Transmitter power:
• Digital controller/diverter battery:
3x 3 V lithium batteries (type CR 2450)
• Type of protection:
Electrical test data
• Software class:
• Contamination class:
• Rated surge voltage:
• Temperature for ball impact test:
The test for electromagnetic compatibility (interference
emission test) was performed at the rated voltage and
rated current.
Approval and conformity
This product conforms to the requirements of the
relevant EU guidelines.
The conformity declarations can be obtained from the following
address:
GROHE Deutschland Vertriebs GmbH
Zur Porta 9
D-32457 Porta Westfalica
Register additional digital controller (36 309)/diverter (48 113/48 114)
Button Description
Start the selection menu (only if there is no water flowing)
Select by pressing and holding the
Select other menu items by turning the ring:
• F3 - Register additional digital controller/diverter
The selection menu is exited by pressing and holding the
button or automatically after 3 minutes has elapsed.
F3 - Register additional digital controller
- Confirm selection by pressing the
digital controller simultaneously.
- Press the buttons of the additional digital controller simultaneously
in order to register it.
- Pressing the
simultaneously saves the selection and exits the menu.
Maintenance
Change batteries, see fold-out page I, figs. [1] to [5].
Batteries which are almost discharged are indicated by
shortened signals of the illuminated ring after pressing a
button. Batteries must be changed at the latest when signals
are no longer detected.
2.4332 GHz
- / +
- / +
- / +
buttons on the existing digital controller
Insert batteries, see fold-out page I, Figs. [1] to [5].
Fasten digital controller/diverter, see fold-out page II,
Fig. [6a] to [9].
Register digital controller (36 309), see fold-out page II,
Figs. [10] and [11].
After replacement, the new digital controller must first be
registered with the functional unit.
< 1 mW
Proceed as follows for fittings:
1. Disconnect battery (A) and power supply unit (B), see
Fig. [10].
IP 55
2. Wait approx. 10 seconds.
3. Reconnect power supply unit (B) and battery (A); there will
be a brief pulse of water after 15 seconds.
4. Register the new digital controller within the next
B
60 seconds by simultaneously pressing On/Off and +.
2
5. The fitting is then ready for operation again.
2,500 V
100 °C
Proceed as follows for thermostat boxes:
1. Disconnect power supply unit (C) or (D), see Fig. [11].
2. Wait approx. 10 seconds.
3. Reconnect power supply unit (C) or (D).
4. Wait 15 seconds. Register the digital controller within the
next 60 seconds by simultaneously pressing On/Off and +.
5. The thermostat box is ready for operation again after a total
of 3 minutes. The buttons on the digital controller are
inoperative during this time.
buttons simultaneously:
Start/Stop
buttons on the existing
Lever off base and change all batteries.
Insert batteries with correct polarity.
Assemble in reverse order.
Disposal note
Dispose of batteries in accordance with national
regulations.
Visualisation
Illuminated ring flashes red 3x
Illuminated ring flashes violet 1x
Illuminated ring flashes green 1x
Illuminated ring flashes green 1x
Illuminated ring flashes green 3x
2