How To Attach - Hoover SteamVac FH50020RM Manual Del Proprietário

How to attach hose
Disconnect carpet cleaner from electrical outlet.
1. To prevent possi-
ble leaking, remove
clean solution tank
by pressing down
on tank handle (D)
and pulling for-
ward; set tank aside
(do not set tank on
furniture).
Remove hose from
storage rack.
5. Before connecting tube (G) to cleaner, make
sure black tabs are extended by pulling collar
toward tube.
Open door on hood labeled "Stair/ uphol-
stery Cleaning Connection". Press round
solution tube connector onto round projec-
tion inside door. Press connector collar down
firmly to ensure that it is fully connected.
6. The tank replaces in a hinge-like manner.
Position front of lid under tabs (H) on front
of tank. Rotate lid down onto tank.
Make sure lid is secure on all sides before
cleaning.
How to attach tool
All tools connect to the hose in the same
manner.
1. Attach tool to connector end of hose by
sliding it onto connector until the tab (I)
locks it securely.
Using your thumb, push forward and up on
the latch (J) to remove tool as shown.
(available on some models)
3.6
D
2. Step on handle
release pedal and
lower carpet clean-
er handle until it
rests on the floor.
Unlatch back part
of recovery tank
and remove lid.
3. Pull recovery
tank front panel (E)
up one inch then
rotate forward so it
is horizontal to
floor.
4. Replace panel
with converter (F).
Slide converter
halfway down
opening until it is
firmly in place.
3.9
For full suction, it is important that the
recovery tank lid is properly secured before
cleaning.
Reverse procedure to remove hose and solution
tube.
Raise carpet cleaner handle to upright position.
3.11
J
15
3.20 3.7
3.8
3.10
G
H
I
www.hoover.com
E
E
F