Tiiwee X1 Home Alarm Starter Kit Manual Del Usuario página 4

Door sensors: Remove the ba ery protec on strip at the back of the
sensor by pulling it.
Mo on detector (if included): Open the ba ery compartment, and
remove the ba ery protec on strip
3. Familiarize Yourself with Your System:
a. Arrange the door sensors such that the magnet is on the right-hand side
of each sensor. The triangles on the middle of the sides of the sensor and
the magnet cannot be more than 5 mm apart.
them so that the triangles are facing each other.
Posi on the mo on detector with the detec on window facing
downwards to avoid that it detects anything for the moment.
Use the Loudspeaker-bu on on the remote control to switch from the
doorbell-sound (2 different volumes) to siren sound. Cover the siren to
avoid damaging your hearing. Press the Loudspeaker-bu on of the remote
control un l you hear the doorbell-sound ("Ding-Dong").
b. Press the Ac va on-bu on ( ) on the remote control to arm the X1-siren.
You hear a short beep accompanied by one brief flash of the LEDs.
c. Now move the magnet away from the first
sensor. You hear the doorbell-sound
("Ding-Dong"), and the red light on the
sensor lights up. Repeat this procedure
for all other door sensors.
IMPORTANT: Posi on
Mo on detector (PIR kits only): Slowly, in front of the mo on detector,
wave your hand at a distance of approximately 50-70 cen metres. You
hear a doorbell-sound, and the detec on window of the sensor lights up.
4. Installing your system
Deac vate the X1-siren using the Deac va on-bu on on the remote
control ( ). Now, mount theX1-siren and door sensors following the
instruc ons in the manual.
How to mount the X1-siren
First, a ach the back panel to the wall using the self-adhesive pads or screws
(included). Place the X1-siren on the back panel and a ach it to the back
panel with the smallest screw at the bo om.
Once all components are mounted, ac vate the system: Select the
Loudspeaker-bu on on the remote control to choose the loud siren sound.
Now, to ac vate your system, press the Ac va on-bu on.
4. Daily use of your alarm system
Switch On/Off
Press the On/Off-bu on on the X1-siren for 5 seconds to switch the unit on
or off. When switching on, you hear one short beep and the LEDs light-up
from top to bo om. When switching the X1-siren off, you hear one long beep
sound, and the LEDs dim from the bo om to the top. When the X1-siren is
switched on, it will be in the same state (ac ve or deac vated) as it was
when it was switched off.
Ac va ng the system
On the X1-siren: short press the SET-bu on. On the remote control: press
the Ac va on-bu on.You hear one beep as a confirma on that the system
is ac vated.
Deac va ng the system
X1-siren: short press the SET-bu on.
Remote control: press the Deac va on-bu on.
Deac va ng the system will be confirmed by two beeps.