Tiiwee X1 Home Alarm Starter Kit Manual Del Usuario página 6

Pairing remote controls
Press the SET-bu on for 5 seconds. You will hear a beep and all four LEDs
light up
Press one (any)-bu on on the remote control(s) which you wish to
connect. You will hear two beeps for confirma on of correct pairing.
Press the On/Off-bu on shortly to store the se ngs
The remote control is now connected to the X1-siren.
Adding addi onal sirens to your system
The system can be expanded with more X1-sirens and A3-outdoor sirens.
Just connect your sensors and remote controls to the new X1 or A3 siren. A
new siren operates independently of exis ng sirens.
Please refer to the below image which outlines the principle.
6. Dele ng accessories or changing the zones
Clearing all sensors from a zone. Reconnec ng sensor to a zone.
Sensors can be deleted from a zone by dele ng all connec on informa on
for a zone. Any sensors thatyou would like to keep in that zone will need to
be reconnected to that zone again.
In the following example procedure, all sensors from a zone are deleted and
reconnected to the new zone(s).
Below is an example for dele ng the door sensor from zone 3 and connec ng
this door sensor to zone 1:
Dele ng zone informa on
Deac vate the X1-siren by pressing the SET-bu on on the X1-siren or the
Deac va on-bu on on the remote control.
Dele ng all sensors from zone 3:
On the X1-siren, press the SET-bu on for 5 seconds. You hear a beep and
all four LEDs light up
On the X1-siren, press the SET-bu on short three mes to select zone 3.
The LED of zone 3 lights up.
On the X1-siren, press the SET-bu on for 5 seconds. This will delete all
sensors from zone 3. You hear four beeps to confirm, and the LED blinks
four mes.
Now, connect the door sensor to zone 1:
On the X1-siren, press the SET-bu on for 5 seconds. You hear a beep and
all four LEDs light up
On the X1-siren, press the SET-bu on short 1 once to select zone 1. The
LED of zone 1 lights up.
Ac vate the door sensor by removing the magnet away from the sensor.
You hear two beeps, and the LED of zone 1 blinks twice.
On the X1-siren, save the se ng by pressing the On/Off-bu on briefly.
The door sensor has now been removed from zone 3 and reconnected to
zone 1.