Tiiwee X1 Home Alarm Starter Kit Manual Del Usuario página 8

Your X1-siren now has been reset to factory se ngs. You can reconnect your
remote controls and sensors.
10.Window & door sensors
IMPORTANT: Please assure that the distance between magnet and sensor
does not exceed 5 mm. The triangles on the door sensor and the magnet
are alignment aids. They must face each other at a distance of a maximum
of 5 mm for the door sensor to work op mally.
Product Overview and Opera on
The door sensor consists of a magnet and a sensor which contains a detector
for changes in magne c fields ('flux'). When the magnet is moved away from
the sensor, the sensor will detect that mo on and will send a wireless signal
to the Tiiwee Alarm unit. The Tiiwee Alarm unit will now emit a powerful
alarm sound or a doorbell-sound ("Ding-Dong") depending on the se ngs
of the Alarm unit.
Sensor
Triangle
mark
The instruc ons for pairing addi onal door sensors with the Tiiwee alarm
system are included in this manual, or can be found on our website
www. iwee.com or one of our Youtube channels.
Installa on of Door sensors
General guidelines:
Do not install the sensor near magnets or magne c devices - this may
cause the alarm to be ac vated accidentally.
Installa on examples
Various installa on examples are shown on the first page of this manual.
Make sure that both the installa on surfaces are clean and free from grease
and dust. It is essen al to respect the maximum distance of 5 mm between
sensor and magnet. Also, please assure that the triangle marks are aligned.
How to mount a door sensor (please see the inside of the front page)
Image 1: Door and doorpost are at the same level. Posi on the sensor and
magnet next to each other and posi on the triangle markers on the sides of
the magnet and sensor as such that they are close to one another.
Image 2: The door is protruding rela ve to the doorpost. Mount the magnet
sideways on the top of the door and posi on the sensor with a few
Magnet
millimetres distance on the doorpost and posi on the triangle markers on
Triangle
the sides of the magnet and sensor as such that they are close to one
mark
another.
Image 3: The doorpost is protruding rela ve to the door. Mount the sensor
sideways on the doorpost and then posi on the magnet on the door with a
few millimetres distance and posi on the triangle markers on the sides of
the magnet and sensor as such that they are close to one another.
IMPORTANT - PLEASE NOTE:
Clean all surfaces carefully before installa on.
The magnet and sensor should be placed on the door and door frame
respec vely. The principle of the system is that an alarm is triggered
when thesensor and magnet are separated because the window or door
is opened.
If possible, mount the sensor on the door frame and not on the door or
window itself. This posi on reduces the wear and tear that occurs when
windows and doors are closed (shocks). It increases the service life of
your sensors.
It is essen al that the sensor and magnet are aligned correctly and are
at the same level using the triangle marks.
The distance between the sensor and the magnet should not exceed
5mm.