Kenmore CROSSOVER MAX 116.10325 Manual De Uso Y Cuidado página 17

PRE-FILTER CLEANING
To Reinstalh
The pre-filter is located inside the dust
cup. Check the pre-filter frequently and
clean when dirty,
1. Remove the dust cup as outlined in the
EMPTYING DUST CUP (page 15),
NOTE: Make sure dust cup is free of
debris before opening.
2. Rotate dust cup lid assembly
counterclockwise as indicated on the lid
and lift off,
Dust Cup LOCKED
;e)
UNLOCKED
(For Cleaning)
3. Grasp pre-fitter
and rotate as
shown to remove.
4. Clean pre-fitter
by gently tapping
over a trash
container. Tap on
several sides to
ensure best
cleaning.
If necessary, rinse with cold water only,
DO NOT use detergent or soap. Allow
parts to dry 24 hours before putting back
into vacuum cleaner.
DO NOT wash in the dishwasher.
DO NOT install damp.
1. Align the
slots on the pre-
filter with the
alignment tabs
inside dust cup
lid assembly.
Tabs _ Slots
'2. Rotate pre-filter
as shown to lock in
place.
3. Replace the lower portion of the dust
cup by aligning marks as shown,
UNLOCKED (For Cleaning).
UNLOCKED
(For =ning)
LOCKED
(For Use)
4. Rotate while pressing downward until
marks align as shown above in LOCKED
(For Use),
5. Reinstall the dust cup, See EMPTYING
DUST CUP (page 15).
=17=