Troubleshooting - Fellowes Quasar e 500 Manual De Instrucciones

CORRECTING A BOUND DOCUMENT
Additional sheets may be include or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For best results empty the tray regularly.
STORAGE
Switch off the machine. Lower the lid. The Quasar-E comb binder is designed to be stored horizontally on the desk.

TROUBLESHOOTING

Problem
No Green power neon
Red standby neon
Punched holes are not central
Machine will not punch
Punch holes are not parallel to edge.
Partial holes
Damaged hole edges
Waste tray leaks
WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workman-
ship for 2 years from the date of purchase by the original consumer. If any part is found
to be defective during warranty period, your sole and exclusive remedy will be repair or
replacement, at Fellowes' option and expense, of the defective part. This warranty does
not apply in cases of abuse, mishandling or unauthorised repair. Any implied warranty,
including that of merchantability or fitness for particular purpose, is hereby limited in
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure. The benefits under Fellowes' Warranty are in addition to other rights and remedies under a law in relation to the machine.
Cause
Machine is not switched on
Machine is overloaded when punching
Edge guide not set
Blockage
Debris is stuck below dies.
Sheets not correctly aligned to punch pattern.
Possibly overloading the machine
Waste tray is not correctly inserted or 'burst
feature' has activated
Solution
Switch on machine at rear next to plug inlet and at the socket.
Press the punch button. The machine will withdraw the punches
and re-set itself. Continue this process until the punch cycle is
complete
Adjust edge guide to correct paper or cover size.
Check waste tray is empty. Check for blockage to paper entry.
Take stiff cardboard and slide into the paper entry. Move the
cardboard sideways to release any stray clippings into the
waste tray.
Adjust edge guide and test punch scrap sheets until correct
Punch plastic covers with paper sheets. Reduce number of
sheets being punched.
Check waste tray is empty and 'burst feature' is closed.
duration to the appropriate warranty period set forth above. In no event shall Fellowes be
liable for any consequential damages attributable to this product. This warranty gives you
specific legal rights. You may have other legal rights that vary from this warranty. The
duration, terms and conditions of this warranty are valid worldwide, except where differ-
ent limitations, restrictions or conditions may be required by local law. For more details or
to obtain services under this warranty, please contact Fellowes or your dealer.
5 5