Numark Total Control Inicio Rápido página 10

TRAKTOR 3 LE CONTROLLER OVERLAY
With Total Control, we have included a special edition of Traktor 3 LE so you can immediately begin DJing. Total
Control's controls are automatically mapped to the most important functions in Traktor 3 LE and we have provided a
convenient overlay for visual reference.
To install the Traktor 3 LE overlay, if not already installed on the unit:
1. Remove the fader caps by gently lifting them up from their base.
2. Gently pull out the existing overlay by lifting it from the top left corner. Put the existing overlay away for safekeeping.
3. Once the existing overlay has been removed, position the Traktor 3 LE overlay onto the Total Control.
4. Gently replace the fader caps.
Once you have installed the Traktor 3 LE software and overlay, run Traktor 3 LE. Please refer to the controller mappings
on the next page of this manual for additional information on how Total Control controls are mapped to Traktor 3 LE.
TRAKTOR 3 LE CONTROLLER MAPPING
Please note: This overlay is intended to function with both Traktor 3 LE and Traktor 3. You will notice that a few controls
have been left unlabeled. When using Traktor 3, you can assign these controls to various different functions in the
software. If you are using the Traktor 3 LE version included with the Total Control, you will notice that these controls have
been already mapped to certain functions in the software. Please see below for explanation of these controller mappings.
1. TRACK - You can use the TRACK knob to scroll
through the music on your computer. Press down on
the TRACK knob to preview the selected track.
the TRACK knob while pressing and holding down the
PAGE button to browse and navigate through your
different drives, folders and playlists.
release the PAGE button, you can then use the
TRACK knob to browse the contents of the selected
folder.
2. PAGE - Holding down the PAGE button while using
certain controls on the Total Control allows for an
additional layer of functionality.
3.
Use
Once you
4.
6
LOAD TRACK - Each virtual deck features a LOAD
TRACK button. Selecting a track and pressing the
LOAD TRACK button will load the track to the
corresponding deck. You can "focus" on one of
the decks by holding down the PAGE button and
pressing the corresponding deck's LOAD TRACK
button. Certain controls on the Total Control will
only address the deck which is currently "in focus".
PLAY - Press the PLAY button to begin playing the
track.