Numark Total Control Inicio Rápido página 6

HOOKUP SCENARIO 1 – WITHOUT MULTICHANNEL AUDIO INTERFACE
If you do not own an audio interface with multiple audio
outputs, please study the connection diagram on the
right.
Connect the Total Control to your computer with
the included USB cable.
Connect your computer's audio output to a
powered speaker
headphones.
Hint: Most built-in computer soundcards feature a
1/8" stereo plug.
system, you may
appropriate cable connectors.
HOOKUP SCENARIO 2 – WITH MULTICHANNEL AUDIO INTERFACE
In this scenario, you are using an external audio I/O
interface with multiple audio outputs, such as the Numark
DJ|IO, via USB or FireWire.
interfaces enable you to send your master mix and your
cue mix on separate audio outputs, allowing you to take
full advantage of cueing while you play.
If you own a multiple output audio interface, please study
the setup diagram on the right.
Connect the Total Control to your computer with
the included USB cable.
Connect your computer to your audio interface
with the proper cable.
interface documentation for correct connection).
Connect one pair of outputs on your audio
interface to a powered speaker system or
amplifier.
Connect your headphones to an alternate audio
output on your audio interface.
Note: You will have to setup your software and hardware so your mix output is being sent to one stereo output,
while the cue mix is being routed to another. Please consult the software and hardware documentation for more
information on routing your audio outputs. For information and an example on how to route audio outputs in CUE
LE and Traktor LE, please read the Routing Audio Outputs sections on the next page.
system, amplifier
Depending on your speaker
need to purchase
Multiple output audio
(Please see your audio
or
the
2