Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. CONNECT WIRING (INTERIOR BLOWER)
Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with
all applicable codes and standards. Before connecting wires, switch power off at service panel
and lock service disconnecting means to prevent power to be switched on accidentally.
Connect cable into wiring box using wire connectors.
Connect wires as follow: BLACK to BLACK, WHITE to WHITE
and GREEN wire under ground screw. Reinstall wiring cover. DO
NOT FORGET TO CONNECT THE GROUND.
12. INSTALL THE BLOWER (INTERIOR BLOWER)
The blower must be installed to the rough-in plate using (4) 3/8" screws for the single blower unit and (6)
3/8" screws for the dual blower unit. Remove the cover from the blower assembly. Remove the impeller(s)
by pulling them out gently (see pictures below).
HD0021
!
WARNING
0
HD0022
- 8 -
1
HD0007
1) Ground screw
Publicidad
Tabla de contenido
