Troubleshooting; Spare Parts - FIXATOR LM Serie Instrucciones De Uso

3.2

Troubleshooting

Faults Potential causes of the fault
observed
The motor The temperature sensor is activated
does not rotate The motor has a mechanical fault
The contactor in the hoist is out of order or
disconnected
The limit switch is activated
Fault in the control circuit
Fault in the power circuit
Power supply fault
Current escape to earth
Batteries of the remote control out-of-order
The hoist does The grooved pulley is worn or dirty
not lift The condenser is disconnected or out of
order
The temperature sensor is activated
The motor is blocked
The contactor on the hoist is out of order or
disconnected
The limit switch is activated
Fault in the control circuit
Fault in the power circuit
The hoist does The temperature sensor is activated
not lower The motor is blocked
The contactors in the hoist are off or
disconnected
Error in the control circuit
Error in the power circuit
The motor is The capacitor is disconnected or out of
powered but service (for single phase hoist only)
stops (snoring The motor is blocked
sound) Power cable section too thin
The hoist does The groove pulley is worn or dirty
not lift the The capacitor is disconnected or out of
load service (for single phase hoist only)
The temperature sensor is activated
Power cable section too thin
The wire rope is inserted in wrong way
Current too The brake is out of service
high The capacitor is disconnected or out of
service (mono phase hoist only)
The motor is blocked
Slow slide The groove pulley is worn or dirty
The brake is worn
The adhesion system is worn or dirty
3.3

Spare parts

Use only FIXATOR original spare parts.
INSTRUCTION MANUAL
Electrical winches LM+
Note and send the information listed on the plate
shown below before requesting parts.
Remedies
Wait for a drop in temperature
Check the motor
Reconnect or replace it
To be checked by a competent person
Check
Verification
Verification
Wait for a drop in temperature
Verification (maintenance)
Reconnect or replace it
To be checked by a competent person
Wait until it cools
Check the motor
Reconnect or change
To be checked by a competent person
Verification
Verification (maintenance)
Replace the power cable
Verification
Verification
Wait until it cools
Replace the power cable
Verification
Verification
Reconnect the capacitor or change it
Verification (maintenance)
Verification
Adjust the brake
Verification
Réf : 1813000204
Page : 14/20
Version : 46/18