Installation Support On A Basis; Reeving For Lifting Of Load - FIXATOR LM Serie Instrucciones De Uso

2.1.3 Installation support on a basis

Use the optional ref 461021.
The push-button box with lateral outlet (ref 461020
supplied with your winch) is required for this
option.
Note: the push-button box with vertical outlet (ref
462020 supplied with the previous models of
winches LM500 and LM300S) remains usable in
the other cases.
This type of installation requires special
precautions:
- The bearing surface on which the unit is
placed must be flat and horizontal.
- This surface must have a minimum Ø120mm
orifice for the passage of the two strands of
cable,
INSTRUCTION MANUAL
Electrical winches LM+
- The device must be positioned so that the
- The device must be propped so that it will not
- The surface on which the unit is placed in
- The load must be in free suspension.
without having placed it beforehand at the vertical
of the hoist.

2.1.4 Reeving for lifting of load

Use the reeving kit ref 540155.
This assembly allows you to double the capacity
(Maxi working load 990Kg/2185lbs) of the device.
In return, the speed is decreased by half.
reeving kit assembled. Additional system must not
be added.
The reeving kit consists of an anchor carrier strand
and a reeving block with a hook and a spring.
The user should note that when reeving, the
required length of wire rope is at least twice the lift
height, plus at least 1 meter of apparent slack
strand.
The limit spring mounted on the lower pulley is
intended to replace the high limit stop.
lifting wire rope, under load, does not rub
against the walls of the hole, and so that the
travel end stoppers on the wire rope can come
in contact with the switch levers.
move on the support. (4 drillings Ø13
available)
support must have the necessary stability and
strength in regard of the safety of the
operation.
With this arrangement, never lift the load
The LM must not be otherwise than with this
Réf : 1813000204
Page : 7/20
Version : 46/18