Panasonic AG-DV2500 Instrucciones De Funcionamiento página 13

POWER
AG-DV2500
MIC
$
Indicator
: When a cassette is loaded, the LED
lights up green. (Likewise when the unit
is in the POWER OFF state.)
When a cassette is being loaded or
ejected, the LED blinks.
DVCAM : When the unit plays back a tape re-
corded in the DVCAM format, the LED
lights up green.
NTSC : The LED lights up green in the follow-
ing cases:
• In the composite video or S-VIDEO
signal input mode and the
PAL switch located at the rear panel
☞
( Page 14) is set as "NTSC".
• A tape recorded with NTSC signals is
played back.
• When NTSC system DV signals are
input while the INPUT switch is set at
"DV".
PAL : The LED lights up green in the follow-
ing cases:
• In the composite video or S-VIDEO
signal input mode and the
PAL switch located at the rear panel
is set as "PAL".
• A tape recorded with PAL signals is
played back.
• When PAL system DV signals are in-
put while the INPUT switch is set at
"DV".
REC INH : The LED lights up red in the following
cases:
• When a cassette with its rear switch
set at the SAVE position is inserted.
• When A.DUB is not possible such
as on tapes recorded in 48kHz mode.
(Approx. 3 sec)
%
A.DUB
1 / 3
REMOTE INPUT CH
OFF LINE 2 / 4
9PIN WIRELESS DV S-VIDEO
2
NTSC/
2
NTSC/
$ ^
DVCAM NTSC PAL REC INH.
AUDIO
%
Audio indicator
This is an indicator for determining the pres-
ence of audio signals (CH audio selected via
the AUDIO OUT SEL item of the AUDIO/VIDEO
menu).
^
Sensor for wireless remote controller
When using the provided wireless remote con-
troller, please point it to this sensor.
☞
( Page 25, "Using the wireless remote con-
troller")
EJECT
MENU
REC PLAY PAUSE
SET
REW FF
STOP
E-13