Power - Panasonic AG-DV2500 Instrucciones De Funcionamiento

PREPARATION
Connecting to the AC adapter
Connect the provided AC adapter to the main unit.
WARNING :
SHOCK HAZARD - DO NOT OPEN.
AVIS :
RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.
DV IN/OUT
AUDIO VIDEO
CH 1/3 CH 2/4 S -VIDEO
LINE
POWER indicator

POWER

AG-DV2500
MIC REMOTE
OFF
9PIN WIRELESS
POWER button
Memo
• Even in the POWER OFF mode, a small
amount of electricity will still flow into the unit.
• When the unit is in the POWER OFF mode,
no operation can be performed except that
of the POWER buttons (on the main unit and
the remote controller) and cassette loading/
ejecting.
Notes
LOW VOLTAGE
Alarm message
E-26
I
N
9PIN REMOTE
NTSC PAL
O
AUX
U
T
DC IN terminal
A.DUB
DVCAM NTSC PAL REC INH.
1 / 3
INPUT CH
LINE 2 / 4
AUDIO
DV S-VIDEO
• Please supply power to the unit via the provided AC adapter. Do
not use other power sources.
• During recording or playback, please do not unplug the DC or
mains cable.
• When the supply voltage is low, the "LOW VOLTAGE" alarm mes-
sage will be displayed. (
Screw
Provided AC adapter
Clamp
DC 12V
DC cord
1.
Connect the DC cord of the AC adapter
to the DC IN terminal of the main unit.
2.
To prevent accidental disconnection of
the DC cord, fasten the DC cord with a
clamp.
1Remove 1 screw followed by the clamp.
2Insert the DC cord into the clamp and fasten
the clamp unto the main unit.
3.
Connect the provided mains cable to
the AC IN terminal of the AC adapter.
4.
Connect the mains cable to the power
socket.
• Power is channeled into the unit and the
POWER indicator lights up red.
(POWER OFF mode)
• If the DC IN MODE item of the SYSTEM
menu is set to "POWER ON" or "PLAY", the
POWER indicator will light up green.
(POWER ON mode)
If it is set to PLAY, the VTR will automatically
start to play the loaded tape.
☞
Page 62)
– Power –
AC
Provided AC
mains cable