Installation - SOMFY Sonesse 40 RTS Manual De Instrucciones

3 Installation

Motor preparation
1) Fit the crown (a) and drive wheel (b) to the
motor.
2) Measure the length (L) between the end of the
drive wheel and the head end.
Tube preparation
1) Cut the tube to the required length.
2) Deburr the tube and remove the debris.
For smooth roller tubes, cut a notch with the
following measurements: e = 6 mm h = 10 mm
Motor/tube assembly
1) Slide the motor into the tube.
For smooth roller tubes, position the notch
previously cut on the crown.
2) Fix the tube to the motor with self-tapping
screws or steel pop rivets depending on the
dimension (L - 5 mm).
Mounting the motorized tube on the
brackets
If necessary, screw the bracket interface on the
motor head.
1) Mount the motorized tube on the end bracket
(c).
2) Mount the motorized tube on the motor bracket
(d).
Wiring
1) Switch off the power supply.
2) Connect the motor according to the
information in the table below.
RANGE
230V-50HZ
120V-60HZ
220V-60HZ
4
1 Neutral 2 Live
Blue Brown
White Black
Blue Brown
Copyright © 2009 Somfy SAS. All rights reserved - V0 - 01/2010
d
3 Earth
NA
Green
1
NA
2
3
3 x 1,5 mm
a
L = ...
L
Ø > 37
e h
L
OFF
1
2
2
3 x 0,75 mm
3
b
c
2