Sun Function; Introduction - SOMFY Sonesse 40 RTS Manual De Instrucciones

6 Sun function

6.1 Introduction

For this function, you need a Telis Soliris
transmitter.
By default, the Sun function is not active.
1) To activate the Sun function, press the SELECT
button on the Telis Soliris transmitter until the
shade jogs.
2) To disactivate the Sun function, press the
SELECT button on the Telis Soliris transmitter until
the shade jogs.
When the intensity of the daylight exceeds the
threshold set by the Soliris sensor RTS, an order
is sent to the shade after 2 min.
The shade goes to the MY position or to its down
limit if no MY position has been memorised.
When the intensity of the daylight falls
below the threshold set by the Soliris sensor RTS,
the shade goes to the sun disappearing position
or stays at its position (MY or Down limit) if no sun
disappearing position has been memorised.
To set the sun diappearing position, see 6.2 part.
The Wind function is not compatible with this
motor.
8 Copyright © 2009 Somfy SAS. All rights reserved - V0 - 01/2010
1
2
OK