Replacement Of A Lost Remote Control; Adding/Deleting Rts Transmitter - SOMFY Sonesse 40 RTS Manual De Instrucciones

7.6 Replacement of a lost remote control

N.B.: This reset deletes all transmitters program-
med, but end-limits, intermediate position and
sensors are retained.
N.B.: Only switch off the current for the motor
where a transmitter is lost.
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 10 to 15
seconds.
3) Cut the power supply for 2 seconds.
4) Switch the power supply back on: the shade
moves during 5 seconds (If the shade position
is an end limit, the behavior of the shade will be
a jog).
5) Press the RTS transmitter (B) PROG button
until the shade jogs: all the RTS transmitters are
cleared and the new RTS transmitter is program-
med in the motor.

7.7 Adding/Deleting RTS transmitter

Find an RTS transmitter programmed in the motor.
Press and hold the RTS programmed
transmitter (A) PROG button until the shade jogs:
the motor is in programming mode.
Press briefly the RTS transmitter (B) PROG button
to add or delete this transmitter: the shade jogs
and the RTS transmitter is programmed or deleted
from the motor.
12 Copyright © 2009 Somfy SAS. All rights reserved - V0 - 01/2010
1
2 sec
3
2 sec
5
PROG.
B
PROG.
A
PROG.
A
2
10 to 15
sec
4
A
PROG.
B
PROG.
B