Rain Bird SST-900i Instrucciones De Operación página 4

Step 3: Connecting the Valve Wires
Common Wire Connection
• Connect one wire from each valve together with watertight
splice connectors; either valve wire will work.
( select a color to be used as your common wire )
• Connect all wires to common terminals on timer.
Watertight Connector
Typical front yard valve manifold
Direct Burial Cable
USER TiP:
If the Valves are too far apart use a spare piece of wire as a jumper.
The SST Series Timers can be used with most hydro-indexing valves. Please contact the valve manufacturer for more information. DO NOT
STOP
connect more than one valve wire to each terminal. Wiring more than one valve to each terminal will damage the timer. Also, if using more
than one timer, do not share "common" wires between them.
Rain Bird Timer
Do not
remove
wires unless
installing
Rain
Sensor
Connect valves
together with wires cut
from the control cable
Direct Burial Cable
Typical fron yard valve manifold
Control Wire Connection
• Connect the second wire on each valve to a wire on
the control cable; connect only one valve to each
wire.
• Connect the other end of the wire to the desired
zone on the Timer (1,2,3, etc.).
(Each numbered zone corresponds to the same number
zone when programming timer)
Do not
remove
wire unless
installing
Rain
Sensor
Direct Burial Cable