Rain Bird SST-900i Instrucciones De Operación página 5

Step 4: Connecting a Rain Sensor
• Remove the jumper wire from the Rain Sensor terminals.
• Connect both Rain Delay Sensor wires to the terminals
marked RAIN SENSOR.
USER TiP:
To save water and money, install a rain sensor, such as
Rain Bird's RSD Rain Sensor, Rain Check Sensor or WR2 Wireless
Rain Sensor. A rain sensor measures rainfall and prevents unnecessary
watering.
If you decide not to use a Rain Sensor with the timer, leave the
STOP
wire jumper in place that connects the 2 terminals; timer will not
work if wire jumper is removed and sensor is not connected.
Step 5: System Check Out
To make sure each system is wired
correctly, cycle through each ZONE
using the WATER NOW feature:
• Turn the dial to the test ZONE and press WATER ONE ZONE NOW.
• The ZONE will start watering for a default 10 minutes.
• Use the Up/Down arrows to adjust the start time and watering durations.
• To stop watering before the time is up, turn dial.
• Repeat on next ZONE until all have been checked.
If the system doesn't check out, refer to the trouble shooting
STOP
tips and then call 1-800-RAIN BIRD (1-800-724-6247).
(Optional)
do not
remove
wire unless
installing
Rain Sensor
Set dial to
desired ZONE
and press
WATER ONE
ZONE NOW
Works with any
standard Rain Sensor.
SELECT AUTO RUN SELECT ZONE
ON DIAL FIRST ON DIAL FIRST
WATER WATER
ALL ONE ZONE
NOW NOW
Rain Bird Timer