Connecting Gas Cylinder - LANDMANN 42262 Instrucciones De Montaje, Mantenimiento Y Uso

Connecting Gas Cylinder

Installing 16.4 ounce disposable propane cylinder
NOTE: Your portable Pantera is set up from factory to
use a 16.4 ounce disposable propane cylinder.
Before attaching propane cylinder make sure the
control knob is in the OFF position.
Remove plastic cap from top of propane cylinder and
screw cylinder into regulator hand tight.
1. Disconnect the propane cylinder from the regulator
valve when the grill is not in use.
2. DO NOT obstruct the flow of combustion air and
ventilation air to the grill.
Use only the gas specified.
Keep the grill on a level surface.
Keep the grease cup empty at start up.
To prevent fire or explosion hazard
when testing for a leak:
1. ALWAYS perform the 'leak test'
before lighting the grill and each
time the cylinder is connected for
use.
2. DO NOT smoke or allow other
sources of ignition in the area while
conducting a leak test.
3. Conduct the leak test outdoors in a
well-ventilated area.
4. DO NOT use matches, lighters or a
flame to check for leaks.
5. DO NOT use grill until all leaks have
been stopped. If you are unable to
stop a leak, disconnect the propane
supply, call for gas appliance service
or your local propane gas supplier.
Checking for Leaks
1. Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
2. Make sure the control knob is in the OFF position.
3. Spray some solution on the tank valve up to the
valve connection.
4. Inspect the solution at the connections for bubbles.
If no bubbles appear, the connection is secure.
5. If bubbles appear, you have a leak. Go to step 6.
6. Disconnect the regulator from the tank and
reconnect. Make sure the connection is tight and
secured.
7. Retest with solution.
8. If "growing" bubbles appear do not use or move
the LP cylinder. Contact an LP gas supplier or your
fire department!
Operation
Prior to the first use, it is important to clean your grill
with heat. This will clean the internal parts by burning
off any residue and odor from the manufacturing
process. To perform this cleaning, operate the grill
for approximately 15-20 minutes at the highest heat
setting with the cooking lid closed.
IMPORTANT
Please read these instructions before attempting to
light the grill.
Failure to follow the five-minute
waiting period may result in an
explosive flare-up, which can cause
serious bodily injury or death.
DO NOT lean over the open grill
when lighting.
lighting instruction
1. Read all instruction before lighting.
2. Open lid during lighting.
3. Push in and turn the desired control knob to the
HIGH position, then press and hold the electronic
igniter button until the flame ignites.
4. If ignition does not occur in 5 seconds, turn the
burner control off, wait 5 minutes, and repeat the
lighting procedure.
5. To extinguish the burner, push in the control knob
and turn clockwise to the OFF position.
Always remove gas cylinder and grease cup before
transporting or storing grill.
14