Simple Controller Function - Pixsys ATR 902 Manual Instalador

Simple controller function

8.3
When this function is active, the controller cannot manage a step cycle but it
regulates according to a single setpoint (programmed temperature) which is
selectable by the user.

Press and follow the points below:
Press
Red display visualizes the
1
CYCLE
selected cycle.
Red display visualizes
2 while green display shows the
START
STOP
setpoint.
Increases or decreases the
3
setpoint value.
The controller modulates the
4 command output to keep the
START
STOP
programmed temperature.
Visualizes ciclically the controller
5
STEP
values.
2 Access to this function may be enabled on parameter 16
Display

2
Increase until visualize
Enter the chosen setpoint.
To modify the setpoint
press and the arrow keys.
STEP
To exit this function, press
for 1".

.
Do

.

START
STOP
ATR902 - User manual 19