Table Of Confi Guration Parameters; 1St Level Parameters - Pixsys ATR 902 Manual Instalador

Press
5 Scrolls parameters.
Allows to modify parameter: red
6 display visualizes (fl ashing) the
STEP
value of the selected parameter.
Increases or decreases the
7
visualized value.
Confi rms data entering (red
8
STEP
display stops fl ashing).
Confi guration ends.
9
START
STOP
The controller is in
Entering password
If it is necessary to modify those of second level, enter password

Table of confi guration parameters

11

1st level parameters

11.1

1 Sensor
Select type of sensor.

Thermocouple type K. Range: -260..1360°C > Default

Thermocouple type S. Range: -40...1760°C

Thermocouple type R. Range: -40...1760°C

Thermocouple type J. Range: -200...1200°C

Thermocouple type T. Range: -260...400°C

Thermocouple type E. Range: -260...1000°C

Thermocouple type N. Range: -260...1280°C

2 Off set Calibration
Number added to visualized process (normally it corrects ambient tem-
perature value).
-99.9...+99.9 tenths of degree. Default: 0.0.
24 ATR902 - User manual
Display


it is possible to modify the fi rst level parameters.
Select the parameter to be
modifi ed.
Enter the new data.
To modify another parameter
back to point 5.
.
Do

.