Loading Default Values; Confi Guration For Installer - Pixsys ATR 902 Manual Instalador

Loading default values

9.6
This procedure allows to restore all default settings.

Press and follow the points below:
Press
Press for 5". Green display shows
1
CYCLE
display visualizes
Flashing digit on green
2
display changes.
STEP
3 Device loads default settings.
STEP
Entering password
to cancel and reset also the cycles, enter password

Confi guration for installer

10
To enter confi guration parameter it is necessary to
Press
Press for 5". Green display shows
1
CYCLE
display visualizes
Flashing digit on green
2
display changes.
STEP
On green display appears the
3 fi rst parameter while red dislay
STEP
shows the value.
Allows to switch from
mnemonic (parameter name)
4
CYCLE
to numeric (parameter number)
visualization (and vice versa).
Display


all default parameters will be loaded. If it is necessary
Display


.
Enter the password

.
Enter the password
Do
with 1st digit fl ashing, red


.

the controller.
Do
with 1st digit fl ashing, red

ATR902 - User manual
.
.
23