EdilKamin Evolution Serie Instalación Uso Y Mantenimiento página 24

VANITY covering assembly
• Equippment and small items:
4 M6x12 screws
4 silicone spacers for the top
8 Ø 6 flat washers
- the 2 M6x12 screws and the 2 M6
flat washers are to be used for fixing
the stone top panel.
- the 2 M6x12 screws and the 2 M6
flat washers are to be used for fixing
the stone bottom panel.
- As for the 4 spacers and the 4 wa-
shers, proceed as follows:
• insert the 4 spacers for stone in the
respective 4 holes in the cast iron top
• Put the ceramic top to verify the
correct flatness
• If necessary, insert a flat washer
between the silicone spacer and the
cast iron top, in order to bring the
ceramic top to level with the stove.
detail "X"
2 screws
The stove is delivered fully assembled. If however you need to dismount the covering, proceed as follows:
Unscrew the rear (54) and the two bars (74) dismount the cover, the cast iron top (72) and the ceramic top (28).
Remove the stone sides (77-78-79) and, if necessary, the two aluminium bars (83) on the base.
Remove the top front panel (24) from the guides on the grille.
Loosen the two screws to remove the bottom front panel (22) as shown in detail "X"
To assemble, proceed in reverse order.
- 24
-