Publicidad
STEP 1 Cut Hole for Housing
CAUTION:
Avoid potential personal injuries and property damage!
●
Drywall covering the wall must not exceed 16 mm (5/8 in.).
●
Box must be mounted between studs that are at least 406 mm (16 in.) apart. After installation there will not be enough space between the
SA808 and the studs for electrical wires/cables, plumbing, ductwork, or insulation. Choose your SA808 location carefully.
1.
Locate the studs using an edge-to-edge stud finder. Verify the edges of the studs using an awl or thin nail. Mark the inner edges of the
studs with pencil.
2.
The open area on the left of the template
a power box on the right side of the housing
1
≤ 16 mm
(5/8 in.)
4
01
should line up the the inner edge of the left stud. This will allow space for the placement of
02
01
. Level the template
2
and use a pencil to mark the open area of the template
01
Inside Wall - Top View
02
01
.
Publicidad
