Getting Started; Turning Power On And Off; Detaching And Attaching The Front Panel - Alpine DVA-9861 Manual De Operación

Getting Started

SOURCE/
(OPEN)
MUTE
POWER
MODE
About the alphanumeric display of this unit
• All English lower case characters are displayed as upper case on
this unit.
• The alphanumeric display in the following table shows
alphanumeric characters/numbers that may be difficult to
distinguish.
Alphanumeric
Display
Alphanumeric
Display

Turning Power On and Off

Press SOURCE/POWER to turn on the unit.
• The unit can be turned on by pressing any other button except TITLE,
Rotary encoder and (OPEN).
Press and hold SOURCE/POWER for at least 2 seconds
to turn off the unit.
• The first time power is turned on, the volume will start from level 12.

Detaching and Attaching the Front Panel

Be sure to push the Rotary encoder inside the unit before opening the
front panel so that the front panel will open completely, otherwise it
may be damaged.
8
-EN
Rotary encoder
TITLE
Push the Rotary
encoder inside
When you push the Rotary encoder again, it pops back out.
Detaching
1
Turn off the unit power.
2
Press (OPEN) to open the front panel.
To close the front panel, press the left side until it locks as
shown in the figure below.
3
Grasp the front panel firmly, slide to the left
then pull to remove.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it
may result in malfunction.
• Do not leave the front panel open, or drive the car with the panel
open as it may result in accident or malfunction.
The Rotary
encoder pops out
,