Polini XP 4T CROSS Uso Y Mantenimiento página 16

16
8- Inflate the front and rear tyres (see section 7.10)
FRONT
1,3 BAR - 18,9 PSI
Minicross
Minimotard 1,5 BAR - 21,8 PSI
9- Fit the front mudguard with the 4 washers and TB M6X16 screws
provided (photo 6). Fit the front number plate inserting the brake
cable in its special slide.
10- Cut the transport tie securing the front brake pump. Fit the
handlebar and fix it to the top fork with the two handlebar clamps
ENGLISH
11- Remove the throttle control cover and fit the cable as shown in
REAR
1,3 BAR - 18,9 PSI
1,8 BAR - 26,1 PSI
03
04
12- Fit the front brake lever and secure the lever bracket with the
05
13- Fit the engine stop button and fix it to the handlebar with its
06
14- Fit the clutch lever and adjust the travel of the lever as you prefer
15- Fit the footrest support first on the engine with the four Allen
and the four Allen bolts M8X30 (See section 9.1) (photo 7).
photo 8. Re-fit the cover (see section 7.7).
screws provided (photo 9) (See section 7.9)
mounting clamp (photo 10).
using the regulator (photo 11) (See section 7.8).
07
08
09
10