Rowenta PURE AIR PU3030 Manual De Instrucciones página 6

Frequency of cleaning/replacing the filters :
Filter
Pre filter
2in1 Active Carbon & Allergy+ filter
NanoCaptur+ filter (only PU3040 model)
These figures are based on tests in which the air purifier is used for 8 hours per day in quiet mode.
You may need to replace the filters more often depending on the air quality and how often the air purifier
is used. The filter replacement indicator (7) will turn on when the filters need to be replaced. To replace the
filters, please refer to the section "Disassembling / Reassembling filters".
Important! When the filter replacement indicator turns on, check whether the filters need to be replaced.
• When the filter replacement indicator (7) turns on, this indicates that the 2in1 Active Carbon & Allergy+
filter needs to be replaced.
• The pre-filter can be cleaned with a vacuum cleaner or rinsed in water.
Important: Resetting the filter
After replacing the filter, press the brightness button (4) for 3 seconds to reset the filter settings.
Performing a force reset:
If you replace a filter before the end of its lifespan, press the brightness button (4) for 3 seconds to reset the
filter settings.
Caution :
If the granules become "white opaque", filter needs to be removed from the purifier until the granules
become transparent again.
If the opaque aspect persists, filter need to be changed.
If the granule become "crumbly", filter need to be changed.
The appliance efficiency can be reduced if the pre-filter is not cleaned regularly.
Never use a pre-filter that is still damp.
The pre-filter is the only filter which can be re-used and washed with water. The 2in1 Active Carbon & Allergy+ filter
cannot be cleaned and re-used. Never wash with water. The 2in1 Active Carbon & Allergy+ filter must be replaced
after the end of its lifespan. For optimum performance of the appliance, only use filters provided by Rowenta. If
the Nanocaptur+ filter granules become opaque white or/and crumbly, the filter needs to be changed.
Please note: certain filters may emit a temporary slight odour, due to the transport and storage conditions.
« TIPS FOR CHANGING FILTERS »
• Avoid handling used filters if you suffer from allergies or asthma.
• Wear gloves when changing the filters, or wash your hands well afterwards.
• Put used filters directly into a closed, air-tight bag before throwing them away to avoid
spreading pollutants.
Pollution sensors
The particle sensor need to be cleaned regularly (every 2 months) and appropriately.
Make sure you turn off and unplug the appliance before cleaning the pollution sensors and follow the
recommendations below:
1. Clean the air inlet and outlet using a soft brush or cloth.
2. Open the sensor cover located on the left hand side of the appliance.
3. Lightly wet a cotton swab and remove any dust from the lens and the inlet/outlet. Wipe using a dry cotton swab.
4. Clean the sensor using a soft brush or vacuum cleaner.
6
Clean/replace
Clean
Replace Every 12 months
Color changing (see
color chart on filter)
Replace
or every 12 months in
case of no saturation.
Frequency
Every 2 months
Filter codes
XD6231
XD6082