Rowenta PURE AIR PU3030 Manual De Instrucciones página 7

IMPORTANT:
Never use a detergent or metal object to clean the sensors.
The efficiency of the sensors may be reduced if not cleaned regularly.
Cleaning frequency varies depending on the operating environment of the appliance. If it is used in a
dusty environment, clean the sensors more frequently.
STORAGE
When you are not using the appliance, store it in a cool, dry place with ambient conditions no higher than 35°C
70%RH.
IN THE EVENT OF A PROBLEM
• Do not disassemble the appliance yourself. A poorly repaired appliance may be dangerous for the user.
• Check the troubleshooting table below before contacting an Approved Service Center:
Problem
The appliance does not
switch on.
The air flow does not
change automatically.
The flow is a lot weaker
than before.
There is an unpleasant
smell coming from the air
outlet.
The air quality indicator
does not change color.
WARRANTY
Do not use the appliance and contact an Approved Service Centre if:
– your appliance has been dropped;
– your appliance or its power cord are damaged;
– your appliance no longer functions properly.
You can find a list of Approved Service Centres on the Rowenta international warranty card.
HELP PROTECT THE ENVIRONMENT!
Your appliance contains many materials which can be recovered or recycled.
Leave it at a local waste collection point or take to an approved service center so that it can be
processed.
These instructions can also be found on our internet site, at www.rowenta.com.
Check
Is the power cord connected?
Are all the display elements off?
Is there a power outage?
Is the appliance in manual mode?
Does the filter need to be cleaned or
replaced?
Is the sensor lens covered with dust?
Does the light still indicate poor air
quality?
Solution
Connect the power cord to a plug
with the correct voltage.
Press the on/off button and select the
required function.
You can use your purifier once the
power turns on again.
Select the correct operating mode.
Check the filter cleaning and
replacement frequencies and clean/
replace the filter(s) if necessary.
Check the filter cleaning and
replacement frequencies and clean/
replace the filter(s) if necessary.
Clean the sensor lens.
EN
7