Operating Instructions - Stanley 3Gal El Manual Del Propietario

OPERATING INSTRUCTIONS

WARNING:
To reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases,
vapors or explosive dust in the air. Flammable gases or vapors include but are not limited to:
lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or aerosol sprays. Explosive
dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not use this vac as a
sprayer for any flammable or combustible liquid. To reduce the risk of health hazards from vapors
or dusts, do not vacuum toxic materials.
WARNING:
The operation of any utility vac can result in foreign objects being blown into the eyes, which can
result in severe eye damage. Always wear safety eyewear complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting operation.
CAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vac for extended hours or
when using it in a noisy area.
This 3-gallon wet/dry vac is assembled at the factory and ready for use when you remove it from the
carton. The unit is ready for dry vacuuming or blowing. After you plug the power cord into the wall
receptacle, turn the unit "ON" by pushing the switch from position "O" to position "I". The "O" is
the "OFF" position and the "I" is the "ON" position.
UNPACKING & SETUP
1. Remove the power-head by pull lid latches in an outward motion, and some accessories that may
have been shipped in the tank(Figure 1&2).
2. Attach casters following the instruction and illustration in this manual.
3. Before replacing power-head,please refer to Dry Pick-up or Wet Pick-p Operation in this manual to
ensure you have the proper filters installed for your cleaning operation.
4. Replace power head on the tank by aligning tabs with lugs by applying pressure at the middle point
of the clip.
5 Attach the extension wands to the accessory end of the hose. Twist slightly to tighten the
connection (Figure 3).
6. Attach one of the cleaning accessories(depending on your cleaning requirements) on the extension
wands. Twist slightly to tighten the connection.
7. Plug the cord into the wall outlet. Your cleaner is ready for use.
1 2 3
O = OFF I = ON
4
6
5