Handle Tube
Tube du manche
Tubo de la manija
Handle Seal
Joint du manche
Sello de la manija
Screw
Vis
Sujetador
Front of Vacuum
Avant d'aspirateur
Frente del aspirador
Handle Seal
Flats
Loquets du joint
du manche
Planos del sello
de la manija
Rectangle Hole
Orifice rectangulaire
Agujero del rectángulo
Flats of Handle Seal Tab
Pressed into Rectangle Hole
Loquets du joint du manche insérés dans
l'orifice rectangulaire
Los planos del sello de la manija tabulan
presionado en el agujero del rectángulo
ASSEMBLY
Attaching Handle
Locking Tab
Languette
de blocage
Tabulación
el bloquear
Rectangular Hole
Orifice rectangulaire
Agujero
Dust Compartment
Compartiment à poussière
Compartimiento del polvo
Handle Seal
Joint du manche
Sello de la manjia
Locking Tab
Languette
de blocage
Locking Tab
Apply Constant
Pressure to
Handle Seal
Maintenir une pression
sur le joint du manche
Aplique la presión constante
de manejar el sello
➢ ➢ Remove the dust bin from the
vacuum cleaner body (see page 32
for Dust Bin Cleaning).
➢ ➢ Remove the large handle screw from
the vacuum cleaner body (found top
center in the back of the dust
compartment).
➢ ➢ Grasp the handle tube and align
locking tab found on the gray handle
seal with rectangular hole found on
the front of the handle tube.
➢ ➢ Press handle seal locking tab down
into the rectangular hole on the
handle tube to lock flats on locking
tab into place (See diagram).
➢ ➢ Carefully insert the handle seal into
the opening located on the top of the
vacuum cleaner body until the
handle seal is flush with the top of
the vacuum cleaner.
➢ ➢ Push the handle tube down into the
vacuum cleaner body as far as
possible. When handle is inserted
properly, the locking tab snaps in
place and prevents the handle from
coming out of the cleaner.
➢ ➢ Carefully align the screw hole of the
handle tube with the screw hole
located in the dust bin compartment
on the vacuum body. Secure the
handle in place with the screw as shown
(see page 32 for Dust Bin Cleaning).
- 12 -