Toto TBV02405U Manual De Instalación Y Del Propietario página 5

II.Installation: Valve (image shown is for TBV02406U)
1. Remove protective cover from
valve body.
a.Make sure O-Rings do not fall
off.
b.Verify "UP" label is facing/reads
correctly. Use hex wrench
(4mm-included) to fasten the
valves with provided screws.
WARNING:
●Be careful when removing
protective cover. Make sure
no O-rings or screws get lost.
●Make sure valve is facing the
correct direction during
installation.
2. Cut off adjustment screw.
a.Take out the fixing cover and use screws to secure it to the valve
installation.
b.Take out the adjustment screw and secure in the corresponding
position. Tighten until it makes contact with cartridge surface, no
further.
Adjustment screw
TBV02405U
INSTALLATION PROCEDURE
Adjustment screw
TBV02406U
Cartridge
Protective cover
UP
Screw
Valve body
Hex wrench
Fixing cover
Screw
WARNING:
DO NOT use an electric
wrench to fasten screws,
these should be tightened
manually.
5
Outlet