Operation; Switching On The Analyzer - Dräger CMS Instrucciones De Uso

Operation

7 Operation
The analyzer and chip should be at roughly the same temperature as the air to be tested in
order avoid condensation on the chip or optical components of the analyzer.
7.1

Switching on the analyzer

Move sliding switch to position 1:

The analyzer performs a function test.
All display elements are activated:
The battery voltage is tested during the
function test:
4 battery symbols (see example)
= batteries fully charged; corresponds
to approx. 450 minutes of
measurement.
1 battery symbol
= batteries must be replaced as their
capacity is too low for further
measurements.
The analyzer is delivered with English setup.
Set a different language:
See "Setting/changing the language version" on page 42.
48
0 0
1 1
2 2
3 3
function test
please wait
01122837_4en.eps
Dräger CMS Analyzer
00922837.eps
01022837.eps