Intended Use; Limitations On Use; Approvals; Label - Dräger HFG 000 Serie Instrucciones De Uso

3.2 Intended use

Dräger X-am 3500 is a portable gas detector for
clearance measurements and for the continuous
monitoring of the concentration of several gases in
ambient air in the workplace and in explosion-hazard
areas.
The X-am 3500 allows measuring up to 4 gases in
accordance with the DrägerSensors (XXS O
LC, XXS CO LC, XXS NO
PR) which are installed. The gas detector can be
operated in pump mode or in diffusion mode.

3.3 Limitations on use

The gas detector is not suitable for measuring process
gasses.
Operation of the gas detector in the charging cradle in a
vehicle is only permitted under the following conditions:
– Acoustic signalling must be deactivated (with the
help of the PC software CC-Vision).

3.4 Approvals

A copy of the rating plate and the declaration of
conformity are provided in the enclosed supplementary
documentation (order no. 90 33 655).
CSA-specific information:
Only the combustible gas portion of this instrument has
been tested for measuring accuracy.

3.5 Label

The energy supply label has a mark for a service label.
Here, a maximum of one service label and one year-
point label may be attached one on top of the other.
More labels may negatively impact inductive charging.
The rating plate on the gas detector must not be
concealed.

3.6 Sensor slot positions X-am 3500

Sensor slot
HPP 1
HPP 2
EC 1-3
Instructions for use | X-am® 3500
, XXS H
2
, XXS SO and CatEx 125
2 2

Configuration

not assigned
CatEx sensor
EC sensors
4

Operation

4.1 Operating concept

Navigation is done with the 3 multifeature buttons and
the dynamic navigation bar (see Graphic E on the fold-
out page). The navigation bar changes dynamically
depending on the available interactions.
S
2

4.2 Symbol explanations

4.2.1 feature buttons

Symbol Explanation
Confirm action/dialog / return to menu
Confirm all
Scroll up / through display
Scroll down / through display
Cancel action
Display quick menu
Display measuring channels individu-
ally
Display all measuring channels
Increase value
Decrease value
Repeat feature
Display menu

4.2.2 Displays

Symbol Explanation
Horn and vibration for gas alarm deac-
tivated

4.2.3 Application

Symbol Explanation
Messen
Fresh air adjustment
Bump test or calibration
|
Operation en
27