Using The Cooktop; Using The Cooktop Elements; Cooking Areas; Hot Surface Indicator - LG LSE3092ST Manual Del Usuario

USING THE COOKTOP

COOKING AREAS

The cooking areas on your range are identified by
permanent circles on the glass cooktop surface. For the
most efficient cooking, fit the pan size to the element size.
Pans should not extend more than 1/2 to 1-inch
beyond the cooking area.
When a control is turned on, a glow can be seen through
the glass cooktop surface. The element will cycle on and
off to maintain the preset heat setting, even on Hi.
Warming zone
Double element Hot surface indictor

Hot surface indicator

The hot surface indicator light will glow as long as any
surface cooking area is too hot to touch.
It will remain on after the element is turned off and until
the surface has cooled to approximately 150°F.
CAUTION
It is normal for the surface elements to cycle on and
off during cooking, even on higher settings. This
will happen more frequently if cooking on a lower
temperature setting.

Using the cooktop elements

To turn on a SINGLE element (left and right rear
elements):
1. Push the single element knob in.
2. Turn the knob in either direction to the setting you
want.
The control knob clicks when it is positioned at both
OFF and HI.
Single element
Triple element
• Hi is the highest temperature available.
• Lo is the lowest temperature available.
• NEVER leave food on the cooktop unattended.
Spillovers can cause smoke. Greasy spillovers may
catch on fire.
• The oven surface element may appear to have
cooled after it has been turned OFF. The element
may still be hot and burns may occur if this element
is touched before it has cooled sufficiently.
USING THE COOKTOP
Double Elemet Warming zone
Single element
Triple Element
Warm
200˚F
250˚F 450˚F
300˚F 400˚F
350˚F
NOTE
CAUTION
17