Lenco PPR-100 Manual Del Usuario página 17

7. Use < and > to set the desired alarm volume
between 0 and 16.
8. Hold down
for a few seconds until the display
stops flashing. Or simply wait a few seconds until
the display stops flashing by itself.
Being awakened
You will be wakened up by the buzzer at the time you
have set.
 Press any button to stop the alarm. You will be
wakened up again 24 hours later.
If you do not press any button, the alarm will switch off
automatically after five minutes.
 To completely disable the alarm function, switch to
time mode and press MEM. The alarm symbol
will disappear from the display.
Turning the guide light on/off
The guide light is connected to a motion sensor. In
automatic mode, the light switches on automatically
once movement is detected and will remain switched
on for approx. 60 seconds.
 Slide the AUTO/ON/OFF switch to...
... ON: the light will switch on permanently.
... OFF: the light will switch off permanently.
... AUTO: the light is set to automatic operation
mode.
In Autolight mode you can manually switch on
the radio or the Bluetooth® function.
17