Using The Alarm Function - Lenco PPR-100 Manual Del Usuario

Depending on your smartphone, you can select
whether you would prefer to have the call transmitted
through the PPR-100 or directly via your smartphone.
Declining a call
Press and hold the button for approx. 3 seconds to
decline an incoming call.
Ending a call
End a call by...
... pressing on the PPR-100.
... ending the call on your smartphone.
Depending on your smartphone, playback may resume
automatically or you may have to start it again using
your smartphone.
Using the redial function
Briefly press twice to call the telephone number
that was last dialed on your smartphone.
Any music that is playing will be paused automatically
and will resume after the call.

Using the alarm function

Setting the alarm clock
To be able to use this function properly, you
need to ensure that the time is set correctly,
see the section titled "Setting the time".
1. Switch on the appliance and select time mode using
MODE.
2. Press and hold
will flash on the display and
underneath.
3. Use the < and > buttons to set the alarm time
(hours).
4. Briefly press
. The minutes display will flash.
5. Use the < and > buttons to set the alarm time
(minutes).
6. Briefly press
. The volume display U... will flash.
16
for a few seconds. The hours
will appear