Lenco CR-630 Manual Del Usuario página 9

Warning: At location with poor DAB reception after power interruption time setting may not recover
and for that wake up by timer could fail.
Deactivate the alarm
With radio on, press Alarm button, and then select the alarm you wish to turn off using the Prev or
Next button to choose the Alarm to OFF position.
Press Enter button.The alarm will be deactivated.
Turning off the alarm
Press the Standby button to turn off the alarm when the alarm is sounding.
NOTE: The alarm will keep ringing for 1 hour if you do not turn it off when it is sounding.
Snooze Function
When the alarm is sounding, press the Snooze button to turn off the alarm temporarily. The alarm
will be delayed for 9 mins and then come on again.
Station information on DAB mode
Every time you press the Info/Menu button in the DAB mode, the display will cycle through the
following display modes:
Dynamic Label Segment (DLS): Displays scrolling text information supplied by the broadcaster.
Signal Strength: Displays a signal bar with the current station strength.
Bit Error Rate (BER): Provides details of the signal error rate.
Channel Frequency: Displays the station's transmission channel number and frequency.
Program Type (PTY): Shows the type and description of the program provided by the DAB+ station.
Time& Date: Displays the time and date information provided by the broadcaster.
Bit Rate: The data rate of which the signal is being transmitted.
Station information on FM mode
Every time you press the Info/Menu button in the FM mode, the display will cycle through the
following display modes:
Radio Text: Displays scrolling test information supplied by the broadcaster.
Program type: Displays description of the program provided by the radio station.
Signal Strength: Displays a signal bar with the current station strength.
Time and Date: Displays the time and date information provided by the broadcaster.
Frquency: Displays the station's transmission frequency.
Audio Type: Displays the audio type of the current station (Stereo or Mono).
Note: To switch between mono and stereo by pressing the Enter button repeatedly.
9