gala gar GALA MIG 3000 Manual Técnico De Instrucciones página 18

Voltage change system of GALA MIG 3000/3800 equipment.
When the equipment leaves the factory it is tagged with the voltage of use that has been selected internally
(normally 400V). In dual-voltage three-phase equipment the voltage can be changed by accessing the inside
of the equipment. Remove the side panel and on the inside you will find a coupler plug. Make the machine
connection as shown in the Figure.
STANDARD EQUIPMENT (230/400 V)
DO NOT FORGET TO FIT THE EARTH CONNECTION INTO THE PLUG.
MAKE SURE THE MAINS VOLTAGE COINCIDES WITH
CARRY OUT THE VOLTAGE CHANGE OPERATION WITH THE MACHINE
GALA MIG 3000/3800.
Power Supply hose (RVK-1KV).
GALA MIG
Length 3000
230 V
10 m 2.5 mm 2
15-20 m 4 mm 2
230 V
400 V
THAT ESTABLISHED IN THE MACHINE.
DISCONNECTED FROM MAINS.
GALA MIG
3800
400 V 230 V 400 V
2.5 mm 2 4 mm 2 4 mm
4 mm 2 6 mm 2 4 mm
SPECIAL EQUIPMENT (220/440 V)
18
2
2
220 V
440 V