Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
PROBLEM
Lid will not sit flush with the
work bowl.
Control panel lights are
flashing.
22
(cont.)
PROBABLE CAUSE/SOLUTION
• Dicing assembly may not be properly installed. See "How to Use" section on page 6.
• Clips are not latched on dicing assembly. Remove lid. Latch the four metal clips on dicing assembly. Place
lid on work bowl and move locking arm up and snapped into place.
• Either the locking arm or large pusher are not properly in place.
• Press STOP, unplug, allow to stand for 15 minutes, and then turn back on.
Publicidad
Tabla de contenido
