Included Components - Shure SBC200 Instrucciones Importantes De Seguridad

SBC200 Charger
The SBC200 two-bay charger holds two SBC900 batteries,
transmitters, or bodypacks. It may be used in any appropriate
location with adequate space and ventilation.
Features
• Charge up to two SB900 batteries, body packs or transmitters
• Connect up to four units using one PS45 Power supply
• LED icons for battery status
• Works with compatible hand held and bodypack units such as
the P9RA, P10R, ULXD1, and ULXD2

Included Components

• SBC200 Charger
• PS45 Power Supply
• Screws for attaching additional units (8)
• Allen Wrench (hex key)
SB900 batteries not included.
Note:
• This equipment is intended to be used in
professional audio applications.
• EMC conformance is based on the use of supplied
and recommended cable types. The use of other
cable types may degrade EMC performance.
• Use this battery charger only with the Shure
charging modules and battery packs for which it is
designed. Use with other than the specified modules
and battery packs may increase the risk of fire or
explosion.
• Changes or modifications not expressly approved
by Shure Incorporated could void your authority to
operate this equipment.
WARNING
• Battery packs may explode or release toxic
materials. Risk of fire or burns. Do not open, crush,
modify, disassemble, heat above 140°F (60°C), or
incinerate
• Follow instructions from manufacturer
• Never put batteries in mouth. If swallowed, contact
your physician or local poison control center
• Do not short circuit; may cause burns or catch fire
• Do not charge or use battery packs with other than
specified Shure products
• Dispose of battery packs properly. Check with local
vendor for proper disposal of used battery packs
• Batteries (battery pack or batteries installed) shall
not be exposed to excessive heat such as sunshine,
fire or the like
WARNING: Danger of explosion if battery
incorrectly replaced. Operate only with Shure
compatible batteries.
1