Area Of Application; General View Of A Standard Installation; Assembling The Release Lever; Disengaging The Motorisation - SOMFY Elixo 500 230 V Manual De Instalación

Elixo 500 230 V

area of application

Sliding gates up to 500 kg and carrying out 100 operations per day.
In order to comply with standard EN 12453, an active edge sensor fitted with autotest electronics (Bircher Reglomat
ref. ElE040/080a0J0/1/XXXX/2 + ref.Esa25-24aCdC) must be installed on the motorisation. after installing the active
edge sensor, it is essential that a stress test be carried out using measurement equipment which conforms to the requi-
rements set out in clause 5.1.1 of standard EN 12445.

General view of a standard installation

A Motor
B Rack
C Aerial
D Orange light
E Set of photoelectric cells
F Key lock
G Active safety edge sensor
H End limit brackets
i End stops in the ground
i
A
iNstallatioN
The motorisation must be disengaged during installation.
assembling the manual release handle
[1] Insert the release handle into the specific housing on the motor.
[2] Tighten the release handle.
[3] Fit the screw cover.

disengaging the motorisation

[1] Turn the key a quarter of a turn to the left.
[2] Turn the release handle to the right.
Do not forcibly push the gate. Hold the gate over its entire travel
during manual manoeuvres.
4
D
C
E
B
G
H
E
F
E
i
C
D
G
E
F
Copyright © 2008 Somfy SAS. All rights reserved.